#60 Winglet Project

Click thumbnail for full size image.

Initial Installation
Ralph Luebke cutting off first wing tip.
Wings shimmed square with fuselage first.
Cut accurately parallels centerline.
Open wing tip.
Wing tip plug (honey comb board).
Finished wing tip.
Wing tip plugs setting up.
Wing tip options.
Checking toe-out angle.
  
The toe-out Angles were wrong, so ...
Correcting toe-out angle.
Toothpick shims set angle.
Temporary pivot pin pulls winglet toward wing.
Plastic plate parallels centerline.
Bottom side view.
Adjusted winglets setting up.
Left in-flight oil-flow shows transition bubble.
Right in-flight oil-flow shows transition bubble.
The Final Result




The Deturbulator Project